A leaky faucet can create many problems at home. Not only does it cause the wastage of a lot of water, but it can also result in ugly stains developing in the sinks in the bathroom, kitchen floors or other areas of the house. It is suggested that a leaky faucet can waste water worth up to 20 USD in a short span of time. This is why it is important to repair them as early as possible.

Causes

A leaky faucet can be caused by a number of reasons; it could be the result of a worn-out washer, or a loose connection in the water line can cause water to drip continuously from the faucet. Sometimes, even a wrong installation may lead to leaks.

Handles and washers

The first thing that you should do to start repairing a leaky faucet is to stop the water supply to the faucet. You may also need to replace the washer of the leaky faucet. To do this, you must carefully unscrew and remove every knob on the faucet. Once you have done it, carefully replace the washer. You should then reattach each part of the faucet as it was before. Remember to tighten all the screws very well to prevent further leakages. This should take care of your problem.

Leaky kitchen faucet

The kitchen faucet is harder to fix than the ordinary bathroom faucet. This is because the bar with an approximate angle of a 360-degree motion range. In the case of kitchen faucets, you must be able to unscrew the cap-end. Once you have done this, you can remove the worn-out washer. Replace it with a new or existing rubber washer. Make sure to screw the metal cap back onto it carefully. This will prevent further leakages.

Troubleshooting

Before you can start treating a leaky faucet, you must identify the exact reason for the leak. In addition, the area needs to be identified accurately. Whether the leak is at the arm base or near the packing nut can be detected easily. Use a wrench to tighten all the screws and nuts. If it continues leaking, you will need to replace the washer with a new one. Again, you must make sure that, after the replacement, you have tightened the screws and nuts well. However, do not make it so tight that it cannot move freely with ordinary effort. Being careful while handling this equipment will ensure that you do not have further problems.